Gypsum Plaster and Stucco Plaster, this range is made available all over the world by us with the objective of supporting innovation in the building of various structures. ApplicationPlaster is applied using hawk and trowel method as per recommended practice, where the thickness in one should not exceed 13mm. Plaster can he applied on most existing surfaces. This suitability of particular background for plastering should be considered in relation to its strength, suction, bonding properties, shrinkage or thermal movement characteristics, water and soluble salt content.ThicknessRecommended thickness for Direct coat plaster should be 12 to15 mm and for Stucco plaster should be 6 to 8 mm. However, for higher thickness, plaster can be applied in more than one application.FixturesOnce the plaster has set, you can put up fixtures of varying weights. Smaller ones can be supported by using steel hooks and pins, while heavier frames and objects can be accommodated with plugs and screws, or suitable fixtures, adequately penetrated into the background to ensure a firm hold.MaintenanceVirtually no maintenance is required after the application of plaster.PrecautionsDuring application of plasters in hot and dry conditions, care should be taken to ensure that rapid loss of water is avoided. The plasters are set to their full strength, provided water is mixed in a specified ratio. If the water dries off too rapidly, then the strength of plaster will be impaired.Packaging and StoragePlasters are supplied in 20 kg and 25 kg HDPE laminated bags which have a shelf life of 13 months. Consignments should be used in strict rotation. To facilitate this, each bag is marked with the batch no. and date of manufacture. The bags should be stored in dry conditions.Site Work Instructions, Bag should be handled carefully to avoid tearing, hooks are not recommended, Prior to plastering,